How to improve the service life of servo motor

The response speed of the servo motor is fast. In the case of point-to-point rapid positioning, the advanced servo control technology provides a large torque output, making the system have ly high dynamic response, thus greatly exceeding the limits of the traditional stepper system.

Because of this advantage of servo motors, this motor has been widely used, which in turn has caused people in various industries to pay more and more attention to its service life. Improving the temperature rise of the servo motor can also increase its service life. So besides this, are there any other methods? The following is about how to improve the service life of the servo motor!

Methods to improve the service life of servo motors include the following:

1. It is customary to use vibration isolation washers to protect the servo motor. When installing this motor, do not over-tighten it to avoid deformation of the vibration isolation washer.

2. Construction workers should pay attention to checking the bearing heating, oil leakage and other phenomena of the servo motor, and then refuel according to the regulations to ensure that its temperature rise does not exceed the rated value.

3. Do not change the power supply voltage arbitrarily. For example, the receiver uses 4.8V. Do not switch to 6.0V in order to improve the performance of the motor to avoid overloading the motor. We must decide according to the nature of the work and the length of the swing arm. The amount of torque.

4. Clean the servo motor regularly. Pay special attention to: do not get water, dust and other debris into the motor.

5. Install, start, and brake the motor according to the specifications in the instruction manual. When the motor is running normally, ensure that its work and power supply quality are within the allowable range.

6. When the servo motor is running, it will encounter many unexpected situations. We should take correct operation protection measures.

7. When replacing the gear of this motor, the user must use ceramic lubricant and do not use mineral lubricant to avoid deterioration of the plastic gear and easy breakage.